Route the NMEA 2000 drop cable to the Intelliducer and to the bottom of the T-connector you added to your NMEA 2000 network. Connect the included T-connector for the Intelliducer in the NMEA 2000 backbone. If you need to extend the NMEA 2000 backbone, connect an appropriate NMEA 2000 backbone extension cable (not included) to the T-connector or terminator you disconnected. Disconnect one side of a NMEA 2000 T-connector, or disconnect a terminator from the backbone nearest to the location where you want to connect the Intelliducer. Determine an appropriate location to connect the Intelliducer to your existing NMEA 2000 backbone. For more information on NMEA 2000, visit To connect the Transom Mount Intelliducer to your existing NMEA 2000 network: 1. If you do not have an existing NMEA 2000 network, you will need to install a NMEA 2000 network on your boat. ![]() Use these two components to connect the Intelliducer to your existing NMEA 2000 network. Yamaha F150LB 2 Yamaha Hubs 6Y8-8 1 Yamaha Engine Device Pigtail 6Y8-8 1 Yamaha Buss Harness 6Y8-8 1 Yamaha Gauge Device Pigtail 6Y8-8 1 Yamaha Power Harness 6Y8-8. ![]() ![]() The Intelliducer is packaged with a NMEA 2000 T-connector and a NMEA 2000 drop cable. To connect a Simrad go9 to your VHF it is best to connect it through an NMEA 2000 network. If you have a NMEA 0183 Thru-Hull Intelliducer, see Step 4 (NMEA 0183). 8 Thru-Hull Intelliducer Installation Instructions Step 4 (NMEA 2000): Connect the Intelliducer to a NMEA 2000 Network Follow these instructions to connect a NMEA 2000 Thru-Hull Intelliducer.
0 Comments
Leave a Reply. |